i'm trying 3/4" floor underlay. we'll see how it goes. the 420 bolt pattern matches my 411s and the 3154s. so once i get the the cabs sealed and reinforced. i can try them.
and yes the tweets are EPI domes (i had them) i left room so i can use a pair of MR 931 12s
believe it or not the cabs are squared. i still have some trimimg and cosmetics left. this week i should be getting the acry-tec texture coating and cab corners
Last edited by Phil-G; September 8th, 2015 at 12:10 AM.
Sonic Barbarian
looking good.
guns kill people,
like spoons made rush limbaugh,
fat ....
Thanks.Originally Posted by tomt
the reinforcement is done. i still have to seal the inside, install the speaker terminal hardware, and the L-pad. but i did clean up the outsides a get them ready to coat them with the Acry-tec. i have the grill figured out. i have some perforated steel cloth i scavenged from a large pair of community speakers. i'm going to make plastic frames with 3/4" king starboard.
the 420As are nice but i need to see what the 411s and the 3154s sound like. either way the EPIs are kinda lost in the fog(figured they would be) and MR 931s will be in order with the 3154s. the 411s might just work for subs.
Last edited by Phil-G; September 15th, 2015 at 09:24 PM.
Sonic Barbarian
where have you crossed them over.
frequency that is ...
guns kill people,
like spoons made rush limbaugh,
fat ....
I'm just using a 5k highpass for the EPIs probly could go lower but I plan on the 931s
Sonic Barbarian
i tried a 3154 and a 411. i like the 411. nice lows. 5 cf seems a bit much for them. i'll need to make a smaller box for them. maybe a dual with 7 cf ?
the 3154 didn't seem to like the cab at all.
Sonic Barbarian
Bookmarks